Home Brewing

Homebrewing - Start All Grain Brewing - Part 4

Т  Continued from Third Installment: Building our Mash TUN _______________________________ Step by Step 1.) Remove the spigot from the cooler. Usually, there"s a nut on the inside of the cooler holding the spigot on. Unscrew that and the spigot should pop right out. 2.) Remove the plastic insert from the hole in the minikeg bung, and insert the bung into the spigot hole, from the inside of the cooler. The beveled edge of the bung goes in first, and the flange of the bung should end up flush with the cooler wall. 3.) Cut off a 6 inch piece of the vinyl tubing and, from the inside of the cooler, insert it into the hole in the minikeg bung. Let a couple inches of tubing protrude from each side of the cooler. 4.) Cut the threaded fittings off the water supply line (I use a hatchet). Pull the tubing out from the braid, leaving you with a hollow length of hose braid. Flatten the last inch or so of one end of the braid. Fold it over on itself 3 times to seal the end. Squeeze the fold with a pair of pliers to crimp it closed. 5.) Slip a hose clamp over the end of the braid, and slip the braid over the end of the vinyl tubing INSIDE the cooler. Tighten the clamp until snug, but don"t squeeze the tubing shut! photos 2nd row #2 and #3 6.) Insert one end of the valve into the tubing on the outside of the cooler and secure it with a hose clamp. Slip another hose clamp over the end of the long piece of tubing, connect the tubing to the output side of the valve, and secure with the hose clamp. That"s it! You"ve built your Cheap "n" Easy mash/lauter tun! Now, let"s brew some beer! http://www.thebrewmeister.info

Add your comment:

Name:
Site address:	http://
Your message:
Enter today\\\\'s date, 2 digits (spam protection):